E
-95MR Hand Control Operation Guide 99300791-
c
7
E-95MR PROGRAMMING
2 hand controls - 1 bed
The three step procedure below is required to program 2 hand controls to operate 1
bed. Before beginning, make certain the bed is plugged into a working grounded
electrical outlet.
If programming fails, initiate the programming procedure a second
time.
STEP 2
On hand control 1, simultaneously press
and hold the
flat
and the
head massage
on/off
buttons
(
FIGURE 3
).
The
transmission indicator light will
flash
slowly
and then
flash rapidly
to indicate
programming mode.
Continue to hold
for 5 seconds and then release the
buttons.
STEP 1
The bed will be equipped with either a
power down box
or
J box
receiver unit
(
FIGURE 2
). Locate the receiver unit for
the bed and press the
learn button
for 1
second and release.
Note: If you
experience difficulty locating or reaching
the learn button on a J box equipped
adjustable bed, refer to
J Box
Programming
on page 5.
J BOX
FIGURE 2: Power down box and J box receiver units.
LEARN
BUTTON
LEARN
BUTTON
POWER
DOWN BOX
POWER DOWN
BOX RECEIVER
UNIT IS NOT
MOUNTED TO
BED FRAME.
J BOX RECEIVER
UNIT IS MOUNTED
TO THE BOTTOM
SIDE OF THE
BED FRAME.
STEP 3
Repeat Step 1 and Step 2 with hand
control 2.
Two hand controls are now programmed
to operate one bed.
HAND
CONTROL 1
HAND
CONTROL 2
FLAT BUTTON
TRANSMISSION
INDICATOR LIGHT
FIGURE 3
HEAD MASSAGE
ON/OFF BUTTON
NOTE
OPERATE ONLY ONE (1) HAND CONTROL AT
A TIME . OPERATING TWO (2) HAND
CONTROLS AT THE SAME TIME WILL
MOMENTARILY BLOCK BOTH RF SIGNALS
AND PREVENT BOTH CONTROLS FROM
FUNCTIONING.