E
-95MR Hand Control Operation Guide 99300791-
c
5
J BOX PROGRAMMING PROCEDURE
When programming the hand control,
unplug the adjustable bed electrical
power cord. Wait 30 seconds, then plug
the cord back in to the power source.
This simple process automatically sets
the bed to the program mode for 90
seconds. For convenience, use this
procedure in lieu of pressing the
learn
button
(located on the J Box, mounted to
the underside of the bed base frame).
J BOX
PROGRAMMING
For adjustable beds equipped with “J box” only—no power down box.
At any point where “
press the learn
button
” is designated, disconnecting and
reconnecting the electrical power cord
will achieve the same function. Note that
this alternate programming feature is
only applicable to beds without a power
down box. Power down equipped
adjustable beds require use of the
learn
button
when programming the hand
control.
POWER DOWN BOX OPERATION
In case of a power outage, press and
hold the
learn button
on the power down
box to lower the bed to the flat position
(
FIGURE 1
).
This function is only for lowering the bed
and will not operate the bed to any other
position. The (2) 9 volt batteries should
be replaced after this function is used.
In the event the power down feature
does not work, check to make sure the
(2) 9 volt batteries are good.
LEARN
BUTTON
FIGURE 1: Power down box learn button.
POWER
DOWN BOX