ADJ Products, LLC - www.adj.com - Vizi Q Wash7 Instruction Manual Page 24
ADJ Products, LLC - www.adj.com - Vizi Q Wash7 Instruction Manual Page 25
Vizi Q Wash7
System Menu
The main menu is accessed by pressing the MODE button. Browse
through the menu by using the UP, DOWN, RIGHT, & LEFT buttons.
Press the ENTER button to access the desired menu. You can scroll
through the submenus using the UP, DOWN, RIGHT, & LEFT buttons.
To confirm every selection press the ENTER button. You can exit
every menu and submenu by pressing the MODE button. The unit will
automatically exit the menus if no buttons are pressed after 10 sec-
onds. These next pages will explain each function in the menu layout
located on the previous page.
RECEIVE -
Set Address -
With this function, you can adjust the desired DMX-
address via the Control Board.
1. Access the main menu, and press the UP or DOWN buttons so
that “
Receive
” is higlighted, then press ENTER.
2. “
Set Address
” will now be displayed, press ENTER. The current
DMX address will now be displayed.
3. Use the UP or DOWN buttons to adjust the DMX address.
4. Press ENTER to confirm or press MODE to return to the main
menu.
USER MODE
User Mode -
This mode will let you select your desired DMX Channel
mode.
1. Press the MODE button to access the main menu. Press the UP
or DOWN buttons so that
“User Mode”
is highlighted, then press
ENTER.
2. Press the LEFT or RIGHT buttons until
“User Mode”
is displayed,
press ENTER.
3. Use the LEFT or RIGHT buttons to scroll through the 3 DMX Chan-
nel Modes.
Standard Mode
- This is 19 Channel Mode.
Basic Mode
- This is 17 Channel Mode.
Extended Mode
- This is 23 Channel Mode.
User Mode A B C -
These are customizable DMX modes. Select
either of these modes and set the amount of DMX Channels and
what each channel does.
4. Press the MODE button once to return to the
“User Mode Set”
menu.
Function -
Status
Address via DMX
- With this function you can adjust the DMX
address via external controller.
1. Press the MODE button to access the main menu. Press the UP or
DOWN buttons so that
“Function”
is highlighted, then press ENTER.
2. Press the LEFT or RIGHT buttons until
“Status”
is displayed, press
ENTER.
3. Press LEFT or RIGHT buttons, until
“Remote Add”
is displayed,
and press ENTER.
4. Either
“Off”
or
“On”
will be displayed, use the UP and DOWN but-
tons to toggle between.
5. Press ENTER to confirm your selection or press MODE to exit.
To use this function follow these instructions:
To adjust the address of your unit you must first go to the
address that it is currently set to. From there you can adjust the
address. First make sure all channels are set to the value of “0”.
1. On your DMX controller set the DMX value of Channel 1 to
the value “7”.
2. Now set the DMX value of Channel 2 to the value “7” to
adjust the starting address between 1 and 255. To adjust the
address between 256 and 511 set Channel 2 to the value “8” .
3. Set the DMX value of Channel 3 to your desired start-
ing address. This will take about 20 seconds before the unit
accepts the new DMX address.
EXAMPLE:
If you want the address to be 57, you must first set
Vizi Q Wash7
System Menu