ADJ VIZ870, User Instructions

Page: 43 / 47

ADJ Products, LLC - www.adj.com - Vizi CMY300 User Manual Page 42
Vizi CMY300 Dimmer Curve Chart
DIMMER
100%
50%
10%
0%
Time (ms)
0 Sec
255 255
0 0
Standard (default) 0 0 0 0
Stage 780 1100 1540 1660
TV 1180 1520 1860 1940
Architectural 1380 1730 2040 2120
Theatre 1580 1940 2230 2280
Dimming Curve
Ramp Effect
Rise Time Down Time
0 sec Fade Time 1 sec Fade Time
Rise Time (ms) Down Time (ms) Rise Time (ms) Down Time (ms)
The glass gobo’s are the only gobo’s that are interchangable in this unit. Remember when changing
these gobo’s that they are glass. Please do this process gently so you do not break the gobo.
Caution! Never open the unit when in use. Always disconnect the main power before attempting to
change the gobos.
Note: Gobo 4 has no retainer ring. The gobo is held in by high temperature silicon sealant.
Locating the Gobo wheel: After disconnecting the main power, position the head with the lens
facing forward. Look through lens of the unit. When looking through the front lens, position the head
so that the gears are on the right side. When the gears are on the right side, the shell that needs to
be uscrewed is now facing up.
1. To change a gobo, uscrew the 4 screws that secure the shell to the unit. The shell is attached to
the unit by a safety wire, gently lift the shell off of the unit.
2. When you remove the shell you will be able to access the gobo wheel. Turn the wheel with your
hand until you come across the gobo you would like to change.
3. You have to remove the individual gobo frames. Gently push the gobo frame (Not the wheel) away
from the gobo wheel, you do not have to the push the gobo frame to far. While you are pushing the
gobo frame away from the wheel, pull the the gobo frame up and out.
4. Once the gobo frame has been removed, you will notice that high temperature silicon sealant is
applied to the retainer ring. Using a small flat head screw driver, very gently scrape away the silicon
sealant to release the retainer ring. After the retainer ring is removed, remove the gobo.
5. Change the gobo and replace the retainer ring. Reapply high temperature silicon sealant to the
same areas on the retainer ring.
6. Insert the gobo frame back into the unit, positioning it in same way as the other gobo frames.
7. Reassemble the unit.
Vizi CMY300 Gobo Replacement (1st Wheel)