©
ADJ Products, LLC - www.adj.com - Ultra Go Par7X User Manual Page 15
©
ADJ Products, LLC - www.adj.com - Ultra Go Par7X User Manual Page 14
Master-Slave Configuration:
This function will allows you to link units together to run in a Master-
Slave mode. In Master-Slave operation one unit will act as the con-
trolling unit and the others will react to the controlling units built-in
programs. Any unit can act as a Master or as a Slave however, only
one unit can be programmed to act as the “Master.”
Master-Slave Connections and Settings:
1. Daisy chain your units via the XLR connector on the rear of the
unit. Use standard XLR data cables to link your units together.
Remember that the Male XLR connector is the input and the
Female XLR connector is the ouput. The first unit in the chain
(master) will use the female XLR connector only. The last unit in
the chain will use the male XLR connector only.
2. Connect the first “Slave” unit to the “Master.”
3. Set the “Master” unit to your desired mode of operation.
4. On the “Slave” unit press the MODE button until “SLAv” is dis-
played. The “Slave” unit will now follow the “Master”.
Ultra Go Par7X Master-Slave Configuration
1. Plug the fixture in and press the MODE button until “dXX” is dis-
played. “XX” represents either “on” or “oFF”.
2. Press the SET UP button until “dEFA” is displayed.
3. Press the UP and DOWN buttons simultaneously. Press the
MODE button to exit.
Battery Life:
This menu is used to check/display the battery life.
1. Plug the fixture in and press the MODE button until “bXXX” is dis-
played. “XXX” represents a number between 0-100. The number
that is displayed is the remaining battery life. If “b---” is displayed,
it means either the battery is dead or your running the unit on AC
power.
Dimming Curve:
This is used to set the dimming curve used with DMX mode.
1. Plug the fixture in and press the MODE button until the DMX
address is displayed.
2. Press the SET UP button until “dr-X” is displayed. This is the dim-
mer setting. “X” represents the dimming mode.
3. Use the UP and DOWN buttons to find your desired dimming
curve. Press SET UP when you are finished.
Ultra Go Par7X Operating Instructions
Ultra Go Par7X Photometric Chart
