ADJ Par ZP100 3K, User Manual

Page: 9 / 22

ADJ Products, LLC - www.adj.com - Par ZP100 3K User Manual Page 9
System Menu: When making adjustments press ENTER to confirm your setup then press and
hold the MENU button for at least 3 seconds. To exit without making any adjust-ments press
the MENU button. The display will lock after 30 seconds, press the MENU button for 3 sec-
onds to unlock.
Addr - DMX Address Setting.
1. Press the either the MENU, UP, or DOWN buttons until “Addr” is displayed. Press ENTER.
2. The current address will now be displayed and flashing. Press the UP or DOWN buttons to find
your desired address. Press ENTER to set your desired DMX address.
Chnd - This will let you select your desired DMX channel mode.
1. Press the either the MENU button until “Chnd” is displayed, press ENTER. The current DMX
channel mode will be displayed.
2. Press the UP or DOWN buttons to find your desired DMX channel mode and press ENTER to
confim and exit.
dnSt - This setting defines the behavior of the fixture in the event that the DMX signal is lost,
interrupted, or power is lost.
1. Press the MENU button until “dnSt” is displayed, and either “BLND or “LAST” will be displayed
beneath.
2. Press ENTER and the bottom choice will begin to flash. Use the UP or DOWN buttons to choose
an operating mode you would like the unit to start up in when power is applied or the DMX signal
is lost.
• BLND (Blackout) - If the DMX signal is lost or interrupted, the unit will automatically go into
stand by mode.
• HOLD - If the DMX signal is lost the fixture will stay in the last DMX setting. If power is ap-
plied and this mode is set, the unit will automatically go into the last DMX set up.
3. Press ENTER to confirm your desired set up.
dInd - This will let select your desired dimmer curve.
1. Press the MENU button until “dInd” is displayed, and press ENTER. 1 of 6 dimmer curves will be
displayed. See the Dimmer Curve Chart section of this manual for details.
• “STDA” (standard)
• “STGE” (stage)
• “TV” (TV)
• “ARAL” (Architectural)
• “THAL” (Theatre)
• (Stage 2)
2. Press the UP or DOWN buttons to find your desired dimmer curve and press ENTER to confim
and exit.
Par ZP100 3K System Menu