ADJ Products, LLC - www.adj.com - Inno Pocket Spot Twins Instruction Manual Page 6
ADJ Products, LLC - www.adj.com - Inno Pocket Spot Twins Instruction Manual Page 7
Power Supply:
The ADJ Inno Pocket Spot Twins contains a auto-
matic voltage switch, which will auto sense the voltage when it is
plugged into the power source. With this switch there is no need to
worry about the correct power voltage, this unit can be plugged in
anywhere.
DMX-512:
DMX is short for Digital Multiplex. This is a universal pro-
tocol used by most lighting and controller manufactures as a form of
communication between intelligent fixtures and controllers. A DMX
controller sends DMX data instructions from the controller to the fix-
ture. DMX data is sent as serial data that travels from fixture to fixture
via the DATA “IN” and DATA “OUT” XLR terminals located on all DMX
fixtures (most controllers only have a DATA “OUT” terminal).
DMX Linking:
DMX is a language allowing all makes and models
of different manufactures to be linked together and operate from a
single controller, as long as all fixtures and the controller are DMX
compliant. To ensure proper DMX data transmission, when using
several DMX fixtures try to use the shortest cable path possible. The
order in which fixtures are connected in a DMX line does not influence
the DMX addressing. For example; a fixture assigned a DMX address
of 1 may be placed anywhere in a DMX line, at the beginning, at the
end, or anywhere in the middle. Therefore, the first fixture controlled
by the controller could be the last fixture in the chain. When a fixture
is assigned a DMX address of 1, the DMX controller knows to send
DATA assigned to address 1 to that unit, no matter where it is located
in the DMX chain.
Data Cable (DMX Cable) Requirements (For DMX and Master/Slave
Operation):
The Inno Pocket Spot Twins can be controlled via DMX-
512 protocol. The Inno Pocket Spot Twins has
two DMX channel modes; 19 channel mode & 23
channel mode. The DMX address is set electroni-
cally using the controls on the front panel of the
unit. Your unit and your DMX controller require a
approved DMX-512 110 Ohm Data cable for data
input and data output (Figure 1). We recommend
Accu-Cable DMX cables. If you are making your
own cables, be sure to use standard 110-120 Ohm
Inno Pocket Spot Twins DMX Set Up
Figure 1
Attaching Brackets, Clamps, & Safety-Cable: Screw one clamp
via a M12 screw and nut to the included bracket. Attach the bracket
using the included screws to the bottom of the Inno Pocket Spot
Twins. Attach the eyehole screw to the side of the base and pull
the safety-cable through the screw and over the trussing system or
a safe fixation spot. Insert the end in the carabine and tighten the
safety screw.
NOTICE:
The suitable enviromental temperature for this lighting fix-
ture is between -25˚ C to 45˚ C. Do not place this lighting fixture in an
enviroment where the temperatures are under or above the tempera-
tures stated above. This will allow the fixture to run at its best and
help prolong the fixture life.
Inno Pocket Spot Twins Mounting
