ADJ ENCORE LP7IP, User Manual

Page: 10 / 30

10
INSTALLATION
CLAMP INSTALLATION
This fixture features a mounting point on the yoke for the attachment of an Omega bracket and
mounting clamp. There is also a safety cable loop located on the rear of the fixture near the display
screen (see the illustration below). When mounting the fixture to a truss or any other suspended or
overhead installation, be sure to secure appropriately rated clamps and Omega brackets (not includ-
ed) to the yoke, and attach a separate SAFETY CABLE of the appropriate weight rating to the safety
cable loop.
SAFETY CABLE:
ALWAYS ATTACH A SAFETY CABLE WHENEVER INSTALLING THIS FIXTURE
IN A SUSPENDED ENVIRONMENT TO ENSURE THAT THE FIXTURE WILL NOT
FALL IF THE CLAMP FAILS.
CONNECTIONS
Ensure all connections and end caps are properly sealed with a dielectric grease (available at most
electrical suppliers) to prevent corrosion, water intrusion, and/or electrical short circuiting. In order
to maintain IP65 rating integrity and prevent water from entering the fixture, all unused con-
nections must be sealed by closing their protective rubber caps.