Ender 3 Belt Kit ADD-ON assembly manual
P a g e
15 | 15
Figure 23 Gt2 timing belt installation
Step 3.6
Faceplate mounting
Using 4 units M4x8 Screws and M4 T-nuts install supplied metal Faceplate at the front
edge of the belt
Figure 24 Faceplate mount
Step 3.7
Wiring
Using supplied Motor wire (1m) connect extruder motor to the extruder port on your
board.
Wire each fan to their corresponding cables originally for the Ender 3 fans (hot-end
and layer fan) soldering might be needed.
Use supplied zip ties for cable management of the extruder harness.
