13
STARTING OF THE MACHINE
1.
Switch on the machine acting upon the general switch (12). For
machines equipped with key switch (see under "OPTIONAL
ACCESSORIES”), turn the key (6) clockwise.
2.
Press the brushes motor switch (5).
3.
Check the battery type and the charge level on the display (1).
4.
Press the suction motor switch (3).
5.
Acting upon the solution valve lever (8) adjust the solution
detergent quantity bringing the floor uniformly wet, avoiding the
leakage of detergent from the splash guard. Always consider that
the correct quantity of solution detergent depends on the type of
floor, dirtiness and machine speed.
Acting upon this lever, the indicator on the instrument board of
the open solution valve (4) will turn on.
For machines optionally equipped with solenoid valve (see under
"OPTIONAL ACCESSORIES”) the flow of detergent solution will be
activated automatically, once the solution valve has been opened
through the lever (8), acting upon the levers forward movement (7).
Releasing these levers, flow will stop automatically.
Models equipped with the 3S system (optional), it is necessary to press
the suitable switch to activate the detergent solution supply by
choosing between the traditional adjustment system through the
solution valve or the system of fixed optimum supply (see under “3S
SYSTEM SOLUTION SAVING SYSTEM”).
6.
Acting upon the brushes base lifting pedal (10) lower the brushes
base.
7.
Acting upon the squeegee lifting lever (9) lower the squeegee.
8.
Activating the levers (7) the brushes will start rotating transferring
to the machine a forward movement. The squeegee will start
drying the floor.
9.
During the first stretches check that the detergent solution flow is
appropriate and that the squeegee adjustment guarantees a
perfect drying action.
FORWARD MOVEMENT
The traction of this machine is given through an electronically
controlled motor.
To move the machine, act upon the key if present, or turn the switch
(5), then rotate the levers drive control placed on the handle bar, in
forward you obtain the forward drive, in reverse the backwards
movement is obtained. The control acts in a progressive way, therefore
it is possible to graduate the speed depending on each requirement
rotating the lever whatever it is necessary. During reverse motion the
speed is reduced.
STOP
Releasing the levers drive control, the machine and the brushes will
stop.
Moving the machine backwards, make sure that the squeegee is lifted.
ADJUSTMENT OF THE BRUSH/ES PRESSURE
Through the register (1) placed on the internal part of the front right
wheel, it is possible to adjust the brush/es pressure on the cleaned
surface.
By turning the wing nut clockwise the pressure increases, rotating the
wing nut counterclockwise, the pressure decreases.
This device allows a more efficient cleaning action also on very difficult
and dirty surfaces.
