10
HOUR METER
The machine is equipped with an hour meter located on the same
display of the battery charge level indicator (1). Keeping the button (2)
pressed for more than 3 seconds, the first data indicates the working
hours and after a few seconds the working minutes are shown.
SQUEEGEE ASSEMBLY
With the squeegee support lowered, slide the two stud bolts (1) placed
on the upper part of the squeegee inside the slots on the support. Block
the squeegee by rotating the lever (2) clockwise.
Insert the squeegee hose (3) into its coupling, respecting its position as
indicated in the figure.
ADJUSTMENT OF THE SQUEEGEE HEIGHT
The squeegee must be adjusted in height depending on the rubber
wear. In order to guarantee a perfect drying during the operation, the
lower blade of the rear squeegee rubber (4) must work slightly bent
backwards (operator side) in uniformed way in all its length.
Acting clockwise upon the two registers (5) it is possible to increase the
bending of the rubber.
Acting counterclockwise it is possible to decrease the rubber bending.
A label placed near the two registers (5) indicates rotation sense to
increase or reduce the height.
Note: The wheels of the squeegee support must be adjusted through
the registers (5) at the same height so that the squeegee works parallel
to the floor.
ADJUSTMENT OF THE SQUEEGEE INCLINATION
In case of need, to increase the rubber bending in the central part, it is
necessary to tilt the squeegee rotating counterclockwise the register
(6). To increase the rubber bending on the squeegee extremities, rotate
the register clockwise.
SPLASH GUARD ASSEMBLY
The two splash guards have to be assembled onto the brushes base
group. Insert the metal strips inside the suitable slots present on the
rubber. Place the round hole at the flat extremity of the strip onto the
screw placed in the front part of the brushes base group. Secure the
strips through the nut blocking it.
Hook the coupling in the rear part of the brushes base group to the slot
placed at the extremity of the metal strip still free. Please act as above
for both the splash guard rubbers, paying attention to reduce to the
minimum the gap between the two rubbers in the front part of the
brushes base group.
With brushes assembled, the splash guard must slightly touch the floor.
