GB
GB
14
6. Open the door (2).
7. Extract the box holding its handle (3). For its
handling, it is convenient to use the two wheels pre-
sent on the opposite part of the handle.
8. Empty the box into appropriate containers, in
compliance with the respective rules what the liquid
disposal concerns.
9. Put the collection box back into its position pay-
ing attention to the correct placing of the sliding
rollers.
10. Close the door (2) and reposition the bar of the
side rubber.
SUCTION FILTER CLEANING
1. Rotate the seat platform forward up to the
blocking of the support.
2. Take off the upper hose (1).
3. Unhook the lever closings (2).
4. Take off the plate with the filters (3) and wash it
with care.
5. Reassemble all parts.
BRUSHES CLEANING
Disassemble the brushes and clean them with a wa-
ter jet (for the brushes disassembly see under para-
graph “BRUSHES ASSEMBLY AND DISASSEMBLY" and
"SIDE BRUSH ASSEMBLY AND DISASSEMBLY”).
ATTENTION:
To carry out brushes disassembly operations with the
electric supply on, may cause damages to hands.
SQUEEGEE CLEANING
Keeping the squeegee clean guarantees always the
best drying result.
For its cleaning it is necessary to:
1. Take off the squeegee hose (4) from the coupling.
2. Disassemble the squeegee (2) from its support (1)
loosening the stud bolts (3) and making the slide in-
side the slots up to release them.
3. Clean with care the internal part of the squeegee
inlet eliminating eventual dirt residuals.
4. Clean with care the squeegee rubbers.
5. Reassemble all parts.
WEEKLY MAINTENANCE
REAR SQUEEGEE RUBBER CHECK
Check the squeegee rubber wear and eventually turn
or replace it.
For the replacement it is necessary to:
1. Take off the squeegee (see under paragraph
“SQUEEGEE CLEANING”).
2. Unscrew the screws (1) that block the rubber
blade and take off the rubber.
3. Turn the rubber to a new side or replace it.
To reassemble the squeegee repeat inversely above-
mentioned operations, inserting the rubber on the
guides and blocking it with the rubber holder blade.
CHECK OF THE SIDE RUBBERS
With the brushes assembled, the side rubbers must
touch the floor. If they are worn, they have to be re-
placed.
To replace the rubbers:
1. Open the bars of the right and left side rubber
after having released them by pulling the stops (1)
upwards.
2. Take off the fixing screws (2) of the inner rubber
blades and replace the rubber.
4. Reassemble all parts.
SQUEEGEE HOSE CLEANING
Weekly or in case of insufficient suction, it is neces-
sary to check that the squeegee hose is not obstruct-
ed. Eventually, to clean it, proceed as follows:
1. Take off the hose (1) from the squeegee coupling.
2. Wash the inside of the hose with a water jet.
3. To reassemble the hose repeat inversely the
above-mentioned operations.
CLEANING OF THE SOLUTION TANK AND OF THE
OUTER FILTER
1. Bring the machine to an appropriate place for
the detergent solution draining.
2. Unscrew the solution tank cap (1).
3. Unscrew the cap of the exhaust filter (2) and
take off the filter. Be careful not to lose the gasket
of the cap.
4. Open the solution valve adjustment (see under
paragraph “FLOW ADJUSTMENT OF THE DETERGENT
SOLUTION”), so that the detergent solution flows
down into appropriate containers.
