Industrial
Electronic Devices
ADFweb.com S.r.l.
User Manual
DALI / MQTT
Document code: MN67941_ENG Revision 1.100 Page 32 of 45
SETUP:
This section defines the parameters of the HD67941 converter.
By Pressing the “
Setup
” button from the menu bar of the DALI Console software, the “SETUP” window appears (Fig. 10).
The means of the fields for the “SETUP” window are:
In the field “
DEVICE IP ADDRESS
” the IP address set inside the converter is defined;
In the field “
DEVICE PORT
” the communication port is defined. It is fixed to ‘10000’;
In the field “
CONSOLE PORT
” the communication port for the DALI commands is defined. It is the one defined in the field “DALI
Console Port” of the section “Set Communication” of SW67941;
In the fields “
SCI x Protocol
” the type of Ethernet communication used is defined. It is possible to leave the default setting;
If the field “
DALI 1 ONLY
” is checked, the converter will manage just DALI 1 communication;
If the field “
DISABLE AUTOMATIC SCAN
” is checked, the converter will stop the automatic scan of DALI network;
If the field “
AutoRefresh
” is checked, the converter automatically refreshes the data when a command is sent.
Figure 10: “Setup” window
