ADF Web HD67843-B2-N, User Manual

Page: 17 / 50

Industrial Electronic Devices
ADFweb.com Srl – IT31010 – Mareno – Treviso INFO: www.adfweb.com Phone +39.0438.30.91.31
User Manual DALI / Modbus Slave - Converter
Document code: MN67843_ENG Revision 1.100 Pagina 17 di 50
SET COMMUNICATION:
This section define the fundamental communication parameters of Modbus and DALI bus.
By Pressing the “
Set Communication ” button from the main window for SW67843 (Fig. 2) the window
“Set Communication” appears (Fig. 3).
The means of the fields for the “Modbus Slave” section are:
In the field “ Baudrate ” the baudrate for the serial line is defined;
In the field “ Parity ” the parity of the serial line is defined;
In the field “ ID Device ” the ID of the Modbus side is defined;
If the field “ Map each DALI Device in a Register ” is checked, the Modbus map (see page 34)
is doubled and a single information for each Modbus register is mapped.
The means of the fields for the “DALI” section are:
In the field “ DALI Console Port ” the UDP port used for the communication with ‘DALI Console’
software is defined;
If the field “ Switch off DALI on Timeout ” is checked, the DALI line is switched OFF if there is
no communication with the Modbus Master for the “ TimeOut (ms) ” defined below;
If the field “ Disable DALI Scan ” is checked, the automatic scan of DALI network is disabled;
If the field “ Enable DALI 2 ” is checked, DALI 2 protocol is enabled.
The means of the fields for the “Ethernet” section are:
In the field “ IP ADDRESS ” the IP address of the converter is defined;
In the field “ SUBNET Mask ” the SubNet Mask is defined;
In the field “ GATEWAY ” the default gateway of the Ethernet network is defined. This feature
can be enabled or disabled pressing the Check Box field. This feature is used for going out of the
net;
Figure 3: “Set Communication” window