Industrial
Electronic Devices
ADFweb.com S.r.l.
User Manual
CAN / Modbus TCP Slave
Document code: MN67515_ENG Revision 2.100 Page 24 of 30
UPDATE VIA UDP (only if “Device from May 2014 (with Dip-Switches)” is set):
By pressing the “
Update Device
” button, it is possible to load the created Configuration into the
device; and also the Firmware, if necessary. This by using the Ethernet port.
If you don’t know the actual IP address of the device you have to use this procedure:
Turn off the Device;
Put Dip2 of ‘Dip-Switch A’ in ON position;
Turn on the device
Connect the Ethernet cable;
Insert the IP “
192.168.2.205
”;
Press the “
Ping
” button, “Device Found! must appear”;
Press the “
Next
” button;
Select which operations you want to do;
Press the “
Execute update firmware
” button to start the upload;
When all the operations are “OK” turn off the Device;
Put Dip2 of ‘Dip-Switch A’ in OFF position;
Turn on the device.
At this point the configuration/firmware on the device is correctly updated.
Figure 8b: “Update device” windows