Industrial
Electronic Devices
ADFweb.com S.r.l.
User Manual
CAN / Modbus TCP Slave
Document code: MN67515_ENG Revision 2.100 Page 23 of 30
UPDATE VIA SERIAL (only if “Device till April 2014 (with Jumper)” is set):
By pressing the “
Update Device
” button it is possible to load the created Configuration into
the device, and also the Firmware if is necessary, using the RS232 port.
In order to load the parameters or update the firmware in the device, follow these instructions:
Turn off the Device;
Connect the RS232 Null Modem cable form your PC to the Converter;
Put Dip2 of ‘Dip-Switch A’ in ON position;
Select the “
COM port
” and press the “
Connect
” button;
Turn on the device;
Check the “Device state” Led. It must blink quickly (see “LEDS” section);
Press the “
Next
” button;
Select which operations you want to do.
Press the “
Execute update firmware
” button to start the upload;
When all the operations are “OK” turn off the device;
Put Dip2 of ‘Dip-Switch A’ in OFF position;
Disconnect the RS232 cable;
Turn on the device.
At this point the configuration/firmware on the device is correctly updated.
Figure 8a: “Update Device” windows