--- ----
---
-----
- -
-- ·-··· ·
--
--·---
Vll.
Operation
Switch
(Figure 12)
1. To tum the lathe •oN•, insert the yellow switch
Fig. 12
key Into the switch housing.
2. Move the switch to the •oN· position.
3. To tum the lathe ·oFF·, move the switch
to the
·oFF·
position.
4. To lock the switch In the
'OFP
position,
remove the yellow switch key from the switch
housing. Store it in a safe place.
5. Never leave the lathe unattended until it has
come to a complete stop.
Speed control (Figure 13)
1. The lathe motor must be running before you
can use the speed control lever.
2. T he speed control lever can be turned to one
of ten fixed speeds. To set the speed, pull back
2
on the lever handle [1] and rotate the handle to
the next fixed speed. Use the index plate [2] to
p=<-�----.i1
choose lathe speed.
3. Tum the lever clockwise to increase the speed
and counterclockwise to decrease the speed.
r----------_ -_-_-_-_----.-,-----,--,
4. You must move the speed control lever to
Fig. 14
the lowest speed setting before turning the
switch off (Figure 14), otherwise the motor
may not
start.
Tailstock (Figure 15)
1. Move the tailstock [1] by loosening the lock
lever [2] and pushing the tails1ock
to
the
desired position on the bed. Lock by
tightening the lock lever (2].
2. The spindle can extend up to 2-1/2 inches
from the tailstock housing. You can
move
the
Flg. 15
tailstock spindle [3] by loosening the spindle
lock lever [4] and then turning the
hand wheel [5]. Lock levers [4} and [2]
before operating lathe.
3. The tailstock spindle is hollow and can be
accessed from the handwheel end. Use the
push-out rod to remove the center cup or to drill
holes through the center of a workpiece.
'-------------------1131-------------------'
