VI • Assembly
Spurs
1. Remove the faceplate [1] from the headstock
spindle using the two wrenches provided
[2]
to separate the faceplate from the spindle nut.
(Figure 5)
2. Insert the headstock spur [31 in the spindle hole.
3. Insert the tailstock center (4] in the
tailstock hole.
(Figure 6)
4. To remove either the headstock spur or the
tailstock center, insert the push-out rod [5]
into the hole (6] at the opposite end
of
the
headstock or-tailstock. Remove and store the
m� ,� �
1�r� ,�utim�
1��r ���,
Faceplate (Figure 7)
1. Remove the headstock spur from the spindle.
2. Thread the 4 inch diameter faceplate le the
spindle.
3. Mount the workpiece to the faceplate with the
flat head brass wood screws. Make sure the
length of the screws does not interfere wilh
the cutting tools.
Extension bed (Figure 8)
1 . The extension bed is attached to the left of
the headstock for outboard faceplate turning
when the use of the tool rest is required.
2. If outboard faceplate turning does not
require the use of the tool rest, do not attach
the extension bed until needed.
3. To attach the extension bed [11 to the bed,
align the bolt holes [2] with the threaded bed
holes [3]. Put the lock washer [4] on the hex
bolt [5]. First finger tighten the hex bolt, then
secure the hex bolt with the hex key provided.
Fig. 6
Fig. 7
'
WARNING:
DO NOT OPERATE YOUR WOOD LATHE UNTIL IT IS
COMPLETELY
�s��\Ji�\..t.� ��\)
�t)j\)12,\£\J
r..cca�O\NG 101\-\t
\NS1�\JC1\0NS.
'----------------�11 '----------------�
