To select charging mode or re-set during charging.
Fault
light on in case of short circuit , reverse polarity , bad battery
Battery is during charging
Battery is full
Mode :14.4V/2.0A
This mode is normally used for all types of batteries <40Ah
Mode :14.4V/8.0A
This mode is normally used for all types of batteries <160Ah
Mode :desulfation
If battery’s voltage is bellow 10.5V and no capacity to absorb
charging current, charger will automatically rise output voltage
up to 17V to recover the battery. If battery can’t be recovered
after 2 hour, “Fault” light will on and the battery maybe spent.
Mode :14.7V/8.0A
This setting is recommended for batteries at temperatures below
5°C. It is also recommended for many AGM batteries. This
setting is not recommended for maintenance charging when the
temperature at times e5°C. In this case, the 14.4V/8A
mode is recommended.
Mode :13.5V 5Amp output
DC power supply for use 12V appliance in home.
Max output power is 80W.
PREPARING TO CHARGE
1.Determine voltage of battery by referring to car owner s manual.
2.if it is necessary to remove battery from vehicle to charge, or to clean terminals, always remove
grounded terminal from battery first. Make sure all accessories in the vehicle are off, so as not to
cause an arc.
3.Clean battery terminals. Be careful to keep corrosion from coming in contact with eyes.
4.Add distilled water in each cell until battery acid reaches level specified by battery manufacturer.
This helps purge excessive gas from cells. Do not overfill. For a battery without cell caps,
