ADEMCO Vista-128B PLUS, Installation And Setup Manual

Page: 50 / 138

VISTA-128B PLUS Installation and Setup Guide
3-30
If the phone plug is disconnected from the
control, the premise’s phones will not operate.
NOTES:
•
When the AAV indicates that the audio alarm
verification session is completed, all keypad sounds
are restored. Sirens are restored if the alarm
timeout period has not expired.
•
As part of its fail-safe software, the control limits
all audio alarm verification sessions to 15 minutes.
This is because once the session begins, the AAV
Module controls the duration.
•
If a new Fire alarm should occur during a session,
the control breaks the phone connection and sends
the new Fire Alarm report, then re-triggers the
AAV Mode. All other dialer messages triggered
during ongoing conversation are held until either
the AAV Module signals that it is inactive, or the
15-minute timeout occurs.
CONTROL/
DIALER HEADER
NOTE:
REFER TO AAV MODULE
INSTRUCTIONS FOR
CONNECTIONS TO AUDIO
SPEAKERS AND MICROPHONE.
•
•
•
•
•
EAGLE
1250
6 7 16 17
27 26 28 29 30
}
ZONE 5
(–) (+) (–) (+)
• • • • • • • •
J7
DIP Switch
1 2 3 4 5 6 ON
CONTROL
EARTH
GROUND
RED (R)
GREEN (T)
GREY (R)
BROWN (T)
INCOMING
PHONE LINE
RJ31X
(–) EDGE TRIGGER (YELLOW)
PIN 3
SYSTEM POWER (RED)
SYSTEM GROUND (BROWN)
BROWN (–)
RED (+)
TIP
RING
EAGLE
SUPPLIED
CABLE
➤ ➤
DIODE FROM
EOLR PACKAGE
TO PREMISES
HANDSET
Figure 3-40: AAV Connections to J7 Trigger
CONTROL/
DIALER HEADER
NOTE:
REFER TO AAV MODULE
INSTRUCTIONS FOR
CONNECTIONS TO AUDIO
SPEAKERS AND MICROPHONE.
•
•
•
•
•
EAGLE
1250
6 7 16 17 27 26 28 29 30
}
ZONE 5
(–) (+)
• • • • • • • •
J7
DIP Switch
1 2 3 4 5 6 ON
CONTROL
EARTH
GROUND
RED (R)
GREEN (T)
GREY (R)
BROWN (T)
INCOMING
PHONE LINE
RJ31X
YELLOW
RED
BROWN
BROWN (–)
RED (+)
TIP
RING
EAGLE
SUPPLIED
CABLE
➤ ➤
13
14
15
16
V+
GND
4204
RELAY 1
SHOWN
OFF
NO NC C
TO PREMISES
HANDSET
Figure 3-41: AAV Connections to 4204 Relay
Module
CONTROL/
DIALER HEADER
NOTE:
REFER TO AAV MODULE
INSTRUCTIONS FOR
CONNECTIONS TO AUDIO
SPEAKERS AND MICROPHONE.
•
•
•
•
•
EAGLE
1250
6 7 16 17 27
26
28 29 30
}
ZONE 5
(–) (+) (–) (+)
• • • • • • • •
J7
DIP Switch
1 2 3 4 5 6 ON
CONTROL
EARTH
GROUND
RED (R)
GREEN (T)
RJ31X
(–) EDGE TRIGGER (YELLOW) PIN 3
SYSTEM POWER (RED)
SYSTEM GROUND (BROWN)
BROWN (–)
RED (+)
TIP
RING
EAGLE
SUPPLIED
CABLE
➤ ➤
4286
4 3 2 1
BROWN (T)
TO PREMISES
HANDSET
GREY (R)
INCOMING
PHONE
LINE
DIODE FROM
EOLR PACKAGE
Figure 3-42: AAV and 4286 VIP Module Connections to the J7 Trigger
Connecting the Transformer
This product uses the 1361 transformer (1361CN in
Canada). If you are using Powerline Carrier devices,
the 4300 transformer interface must be used instead of
the regular 1361 transformer. The 4300 supplies the
control panel with AC, and also sends control pulses
through the premises electrical system to control the
Powerline Carrier devices.
UL
Use 1361CN Transformer in Canadian
installations.
Power Limiting Outputs
All outputs are power-limited as per UL985/UL1023.
The following table shows the maximum current that
may be drawn from each output.
Output Maximum Current Draw
Auxiliary Power 750mA
Polling Loop 128mA
Alarm Output 1.7A