ADEMCO AVR30, Instruction Manual

Page: 6 / 28

AVR30 (E) QR33851
5
ENGLISH
[FRONT]
DISPLAY (See page 7) 1
3
2
4 5 6 7 8 9 10 11 12 13 14 15 16 18 17
S
CONTROLS AND FUNCTIONS
1. RESET BUTTONS
Press these buttons at the same time to clear all
(microprocessor) functions.
Press the “S” button to reset the system. (This does
not erase the stored information.)
2. CASSETTE COMPARTMENT
3. SHARPNESS CONTROL
Adjust the picture quality to hard or soft during play-
back.
4. TRACKING CONTROL
Adjust to optimize the picture quality during playback
at the 06, A18 and A30 hour speeds.
5. SLOW TRACKING CONTROL
Adjust to optimize the picture quality in the SLOW
PLAY mode, e.g. speed 30 hours of field
advance/reverse mode.
6. V. LOCK CONTROL
Reduces vertical jitter in the still play mode.
7. PROGRAM BUTTON
Press to select one of the seven programmable func-
tions.
8. START/STOP BUTTON
Press to start or stop the programming of a program-
mable function. (Press once to start the programming
sequence and a second time to stop (end) it.)
9. SET BUTTON
Press to select the specific value which is to be
changed with the UP/DOWN buttons.
10. DOWN BUTTON
Press to decrement, change or reverse to the
previous/lower value.
11. UP BUTTON
Press to increase, change or advance to the next
higher value.
12. V-POS (VERTICAL POSITION) BUTTON
Press repeatedly to control the vertical position of the
programmable display on the monitor.
13. H-POS (HORIZONTAL POSITION) BUTTON
Press repeatedly to control the horizontal position of
the programmable display on the monitor.
14. ALARM INDEX BUTTON
Press this button to cause the INDEX indicator to light,
and set the VCR to the visual search mode (press
F.FWD or REWIND during playback mode) in this
state; the start of the alarm recorded can be located.
15. ALARM RESET BUTTON
Press to clear POWER LOSS information. When this
button is pressed when the ALARM MEMORY screen
is being displayed, the alarm memory is cleared.
16. COUNTER RESET BUTTON
Press to clear the digital counter to “00000”.
17. REC/PLAY HOURS BUTTONS
▲
(UP): Press to increase hours to the next
higher value.
▼
(DOWN): Press to decrease hours to the next
lower value. The tape speed will be
indicated as part of the monitor display.
18. TIMER BUTTON
Press after programming the TIMER for automatic
TIMER recording. See page 15 for TIMER program-
ming.