3
6128RF Programming
The 6128RF is shipped with preprogrammed default values. Below is a chart showing these values and also,
diagrams showing the wireless keys' loops and their default function. Regardless of which wireless key you use
(even if it is one not shown), loops 1-4 are defaulted for all 8 devices as shown. These values may be changed to
suit the installation.
Entering Program Mode
Press the [1] and [3] keys simultaneously for a few seconds within 30 seconds of applying power. The keypad
will beep 3 times, and two dashes and two zeroes will flash alternately in the upper left-hand corner of the
display. If any other numbers or letters are flashing in the display, press the [
✳
] key.
Pressing the [1] and [3] keys 30 seconds
after
applying power will allow you to enter the
User Mode
. This
mode provides a means to enable and disable individual local wireless keys (i.e., if a user accidentally loses a
wireless key). See the User Guide for the procedure.
Programming Operations
Once you have entered the program mode, you may move to any program address simply by entering the
program address number. The 6128RF will automatically exit the program mode if no keys are pressed for 30
seconds. While in the program mode:
•
The [
✳
] key stores the information, then moves you to the next prompt. (The keypad will beep twice.)
•
The [
#
] key erases the current information, and moves you back so you may enter the correct information.
Enter a Program Address (e.g., press
[1]
for Keypad Address;
[2]
for Receiver Address) to set the parameters in
the 6128RF. The following chart lists the program addresses, the keypad display and the choices.
Program
Address
Description Display Choices
Default
1 Keypad
Address
cA 01-31
31
2 Receiver
Address
rA 00-30
00
3 House
ID
hI 01-31
4 House
ID
Source
hS
1 = System
0 = Local
1 (System)
5
Wireless Key Editing
d-
Enter Existing Device
Number
6 Receiver
Enable
r-
1 = On 0 = Off
1 (Enable)
7
Transmitter Module Enable
tE
1 = On 0 = Off
1 (Enable)
8
Wireless Key Auto Enroll
d-
Enter Serial Number
8 then 2
Wireless Key User Code
u4
Enter 4-Digit User Code
8 then 4
Wireless Key Loop Function
Ln
Enter Loop Number then
Function (See
Wireless
Key Function Chart
)
Loop 2
1 (Disarm)
Loop 3
2 (Arm Away)
Loop 4
3 (Arm Stay)
8 then 5
Wireless Key On-Board
Relay Assignment
o-
Enter Loop Number then
Relay Action
Loop 1
4 (Close for 2
Seconds)
9 Restore
Defaults
EE
1 = Restores Defaults
Any Other Key = Does
Not Restore Defaults
0
High Security Mode
✳
En
1 = Enable; 0 = Disable
0 (Disable)
✳
When the High Security mode is enabled, only encrypted wireless keys will function regardless of whether
they are programmed into the 6128RF or the control panel. All other wireless keys will be disabled.
