a) Press the on battery cover button, slide the battery cover upward and remove it, you can see
one hole at each side, and inside each hole there is a button for setup;
Specific operations:
Trinity 788 Operation Manual
Trinity 788 Operation Manual
b) Remove either of the four batteries, pressing the buttons on the front side to confirm the power
is successfully cut off, then insert into the two holes to press the buttons inside with two slim
objects (e.g. iron wire) at the same time, hold it tight (not to release), and reload the battery. The
lock is then re-powered, if you hear a toot sound after 5 seconds, the initialization of the lock is
successfully completed, and you may loose the slim objects.
Note:
After initialization of the lock, all the enrolled fingerprints and password in the lock are cleared,
and the lock resumes to the new lock state (factory setting). Any finger can open the door, and
master fingerprints, member fingerprints, as well as spare passwords need to be set again.
III. Enrollment of master fingerprints / member fingerprints
Enrollment of master fingerprints (take user
01
as an example)
Operational procedure
Indication of the lock
In the state of new lock, put any finger on the fingerprint
collection window to enter the door open state
Green light is on, and the LED displays
--
Press Button
+
to enter the enrollment mode
A beep sound heard, and the LED displays
0-
Press or - to adjust the first digit 0 of the
fingerprint code, and press Button # to confirm the choice
The tens place displays the figure that has just
been set, while the ones place displays
0
Continue to press Button + or - to adjust the second digit
1 of the fingerprint code, and press Button # to confirm
The LED displays the fingerprint
code 01
flashing
Press Button
#
to reconfirm
the fingerprint code
01
The LED displays fingerprint code
01
,
with red light on the fingerprint window
Put the finger to be enrolled on the fingerprint
collection window, and collect twice
When the red light of the fingerprint window is on,
press with the finger; after the beep, remove the finger
and press one more time. A long beep will sound and
the two collections are successfully completed
The LED displays the code
01
and enrollment
finished. Light on fingerprint window turns off and the
LED displays
0-
,continue to set other fingerprints
The first master fingerprint is set
07
08
