02/25/00
38 - Microsense II Model 5300 Gaging System
Jumper Settings
Bandwidth
The Model 5130 may be set to one of four bandwidths. Use the
following table to determine the jumper settings:
Bandwidth
P4
P14
P11
P15
100 kHz
IN
OUT
IN
OUT
20 kHz *
OUT
OUT
OUT
OUT
5 kHz
IN
IN
IN
IN
1 kHz
OUT
IN
OUT
IN
*default setting
Configuration Adjustments
The Model 5130 has features enabling you to adjust electrical parameters of the internal printed circuit
board to suit your application. These parameters are listed below, along with the default settings set at the
factory.
Configurable Function
Default Configuration (if applicable)
Output Scaling:
+10 volts for probe range
Bandwidth:
20 kHz
Chassis GND Enable:
Grounded (See Appendix A)
Gain Setting:
Adjusted at factory
Linearity Setting:
Adjusted at factory
NOTE:
Probe range is a function of the last two items listed above. These
jumpers are set at the factory for a specific range.
Descriptions of individual parameters follow. If any configurable items need to be changed, refer to the
illustration titled "Model 5130 Jumper Locations" (in the pages which follow) to locate the position of the
jumpers on the PCB.
Board/Jumper Access
Remove the four screws holding the aluminum cover on. Remove the cover.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
