Chapter 5
Using DVD DigiCopier as an external DVD±R/RW on your
PC
Installation
#
Connect the power cable to the back of the DVD DigiCopier.
#
Plug in the Power Cord to the AC Power Source
(+90~+250VAC)
#
Connect the Interface cable to the back of the
DVD DigiCopier
and the other end to your computer or Notebook interface port.
#
Set the switch (S1 on figure 1, page 6) at the back to External
position. Power On the unit at the front to start the
DVD
DigiCopier.
#
LED Display will now lit at the front, will do a series of check, will
check Firmware version. Once the initiation is completed (about
10 -15 seconds), both the Power light and the External light will
stay lit.
#
You are now ready to use the DVD±R/RW drive (the bottom
drive) in the
DVD DigiCopier
as an external storage device
connected to your computer.
#
When the
DVD DigiCopier
is used on a Computer, Only the
DVD±R/RW drive at the bottom Works. The DVDROM drive at
the top will be DISABLED
Addonics Technologies –
DVD±R/RW
DigiCopier Users Guide v1.0
9