ADDONICS TECHNOLOGIES
Model: CDSC-02
IV. Authentication Procedure
1. Inserting the Smart Card
To begin authentication, simply insert the smart card with the
contacts facing down into the Cipher Drive SC. Once a valid
card is inserted, the Status LED will blink once. If an invalid
card is inserted, the Error LED will light up.
2. Entering PIN
Once Cipher Drive SC recognizes that a valid card is
inserted, you may proceed to enter your 8-digit PIN.
The default
factory PIN is “
12345678
”.
The default factory pin is different from the default factory
Admin pin.
At the end of PIN entry, press the Enter button.
Note:
If an incorrect PIN is entered, the Error LED will blink
continuously. Press the Esc button to restart Cipher Drive
SC. If you have mistyped your PIN, press the Esc key at any
time to restart the entire authentication process.
You will be LOCKED-OUT of your smart card after 8
incorrect PIN attempts.
V. Setting up the drive
After you have successfully authenticated yourself to Cipher
Drive SC, drive access will be granted. The connected
drive will then present itself to the operating system as a
removable drive. Please wait for a few seconds for this
process to fully complete. The mounting duration depends on
your drive and operating system.
Once the drive appears in your operating system, you may
proceed to use it like a normal hard drive.
To set up a new hard drive, you have to partition and format it.
Follow your operating system‟s instructions on how to do so.
As with any other storage solution, please ensure that you make
regular backups of your data to protect against possible data
loss.
VI. Disconnecting the drive
To disconnect Cipher Drive SC
, follow your operating system‟s
proper device removal process.
VII. Smart Card Security Features
You can perform certain smart card related security functions
with Cipher Drive SC. These functions are only available
before/during authentication.
CAUTION: Smart Card security and administrative functions
must be performed carefully as they cause changes in smart
cards and associated PINs. Please read the following instructions
carefully and follow them when performing administrative
functions.
The following functions are available.
A. PIN Change
Note:
Please note that smart card PINs are specific so changing
the PIN with one smart card does NOT automatically change the
PIN of another.
You can change your smart card PIN with Cipher Drive SC. It is
recommended that you change the default factory PIN to another
one that only you know.
Follow these steps to change your PIN.
1. Insert smart card into Cipher Drive SC.
2. Press the Change
Pin button, followed by the „1‟ button.
3. Press Enter. The Status LED will blink three times.
4. Enter the current 8-digit PIN and press Enter. The Status LED
blinks twice to notify that you may press the new PIN.
5. Enter the new 8-digit PIN and press Enter. The Status LED
blinks twice to notify that you may press the confirmed new
PIN.
6. Enter the new confirmed 8-digit PIN and press Enter.
Upon a successful PIN change, Cipher Drive SC will proceed to
connect the drive. At the same time, the Status LED will
blink three times and there will be two „beep‟ sounds upon a
successful PIN change. If not, the Error LED will blink
continuously.
Note:
Cipher Drive SC only accepts 8-digit PINs. If a shorter
or longer PIN is entered, the Error LED will blink
continuously. Press the Esc button to restart the
authentication process again. You will need to restart
the entire PIN Change process from step 2.
Pressing the Esc key restarts the entire authentication
process.
Smart card PINs are specific to the physical smart card.
Please be aware that you may have different PINs for
each of the two included smart cards.
Again, you will be locked out of your smart card after 8 incorrect
PIN attempts.
