Addi-Data MSX-E1701, Manual, Page: 13 / 51

MSX-E1701: Digital I/O Technical data
Optical isolation: ........................................1000 V
Cable length: ..............................................150 m (max. at CAT5E UTP)
Bandwidth: .................................................10 Mbps (auto-negotiation)
100 Mbps (auto-negotiation)
Protocol: .....................................................10 Base-T according to IEEE802.3
100 Base-TX according to IEEE802.3
MAC-address: ............................................00:0F:6C:##:##:##
(unique for each device)
4.3.2 Trigger input
Number of inputs: ......................................1
Filter/protective circuitry: ..........................Low-pass/transorb diode
Optical isolation: ........................................1000 V (through opto-coupler)
Nominal voltage (external): .......................24 V
Input voltage: .............................................0 V to 30 V
Input current:..............................................11 mA (at 24 VDC, typical)
Input frequency (max.):..............................2 MHz (at 24 V)
4.3.3 Synchro inputs and outputs
Number of inputs: ......................................1
Number of outputs: ....................................1
Optical isolation: ........................................1000 V
Output type:................................................RS485
Driver level (Master) V
A-B
: ........................ ≤ 1.5 V (low)
≥ - 1.5 V (high)
Receiver level (Slave) V
A-B
:....................... ≤ -200 mV (low)
≥ 200 mV (high)
4.3.4 Digital inputs
Number of inputs: .....................................16 (2 per female connector/ common
ground acc. to IEC 1131-2)
Filter/protective circuitry: ..........................33.9 kHz low-pass, 1
st
order
Overvoltage protection:..............................30 V
Optical isolation: ........................................1000 V (through opto-coupler)
Interruptible inputs:....................................No
Interrupt compare logic:.............................No
Nominal voltage (external): .......................24 V
Input voltage: .............................................0 V to 30 V
Input current:..............................................at 24 V:
11 mA (typical)
at 16.6 V: 6.3 mA (typical)
at 30 V: 17 mA (typical)
Input frequency (max.):..............................5 kHz (at 24 V)
Logic input levels:......................................UH
(max.)
: 30 V/17 mA (typical)
UH
(min.)
: 19 V/ 8 mA (typical)
UH
(max.)
:14 V/4 mA (typical)
13