ADC Modem MM701G, User Manual

Page: 52 / 108

Setting Up the WAN
46 MM701G User Manual
2 Select a session by typing the session number at the Select session for editing prompt to
display the WAN Session Options screen.
3 Type
10
to select the VPI parameter, then enter the values supplied by your service
provider.
4 Type
11
to select the VCI parameters, then enter the values supplied by your service
provider.
5 If you are operating in Router mode, you also need to enter the WAN ADSL Port ID
address and the associated WAN IP subnet mask. Both of these values are provided by your
service provider.
6 Select
Apply
to activate your changes.
Apply
immediately activates the changes that you have
made for this session.
7 Select
Save New System configuration
from the Main Menu as described in “Saving the
Current Configuration” on page 60 or the changes will be lost upon reboot or power cycle.
Session Parameters
1. Session Name Bridge 10. VPI 0
2. WAN Protocol RFC1483 Bridge 11. VCI 35
3. State Enabled 12. QOS UBR
4. IP Addressing N/A 13. QOS Peak Cell Rate
5. IP Address N/A 14. Encapsulation LLC
6. IP Net Mask N/A 15. Login Name N/A
7. NAT N/A 16. Login Password N/A
8. RIP Send N/A 17. Authentication N/A
9. RIP Accept N/A 18. Apply
Select parameter to edit (Return to exit) ->