113354-23
23
F. ELECTRICAL INFORMATION
1. Electrical Requirements
All electrical connections must be made by a properly licensed and competent electrician. This is to
ensure that the electrical installation is adequate and conforms to local, state, and national regulations or
codes of the country of destination. In the absence of such codes, all electrical connections, materials, and
workmanship must conform to the applicable requirements of National Electric Code ANSI/NFPA 70, or
in Canada, Canadian Electric Code CSA C22.1.
For personal safety, the dryer must be electrically grounded in accordance with local codes and/or National
Electric Code ANSI/NFPA 70, or in Canada, Canadian Electric Code CSA C22.1.
IMPORTANT: Failure to comply with these codes or ordinances, and/or the requirements stipulated
in this manual can result in personal injury or component failure.
NOTE: Component failure due to improper installation will VOID THE WARRANTY.
Each dryer should be connected to an independently protected branch circuit. The dryer must be connected
with copper wire only. DO NOT use aluminum wire; it could create a fire hazard. The copper
conductor wire/cable must be of proper ampacity and insulation in accordance with electric codes for
making ALL service connections.
NOTE: The use of aluminum wire will VOID THE WARRANTY.
Outside Ductwork Protection
To protect the outside end of the horizontal ductwork from the weather, a 90° elbow bent downward
should be installed where the exhaust exits the building. If the exhaust ductwork travels vertically up
through the roof, it should be protected from the weather by using a 180° turn to point the opening
downward. In either case, allow at least twice the diameter of the duct between the duct opening and the
nearest obstruction.
IMPORTANT: DO NOT use screens, louvers, or caps on the outside opening of the exhaust
ductwork.
Summary of Contents for AD-190
Page 60: ...ADC Part No 113354 23 06 21 21...