ADC 150-2248-01, User Manual

Page: 42 / 74

Provisioning 150-432-100-02, Revision 02
34 July 18, 2002 HLU-432 List 1
View System Inventory Screen
The System Inventory screen ( Figure 18 on page 35 ) lists the six possible units that can comprise one HiGain
circuit: one HLU, one HRU, and up to four doublers. The information in the System Inventory Screen is presented
as follows:
• All six possible unit modules are always listed. The doublers are shown as: DB1, DB2, DB3, and DB4.
• The model number, list number, and software revision number of every unit that is present in the circuit is
listed in the Product column. Units that are not detected are not considered to be present in the circuit and are
labeled
N/A
.
• Each of the unit IDs is limited to 24-character alphanumeric characters. To change an ID, select its line
identifying letter. The IDs, like the system settings, are stored in NVRAM and thus remain when power is lost.
• The HLU has no unit ID number since it is usually identified by the Circuit ID number, which appears in every
screen.
• All detected modules have the product number listed. Whenever the HLU-432 loses sync with Span 1, the
product types are replaced by the
N/A
label until sync is reestablished and each module can, in turn, be
reidentified. Only the Circuit ID appears in the other HLU-432 Terminal Maintenance screens.
Press at the Maintenance Terminal Main Menu to display the System Inventory screen ( Figure 18 and Figure 19
on page 35 ).
From each System Inventory screen (depending on the number of doublers), you can do the following:
1 Select the unit for which you want to set the circuit ID by pressing the letter that precedes the unit name.
2 Enter the circuit ID, then press .
You can use up to 24 alphanumeric characters for the circuit ID. If more than 24 characters are entered, a
warning beep is emitted and only the first 24 characters are accepted.
3 To set the circuit ID for another unit, repeat Step 1 and Step 2 .
4 Press to exit the System Inventory screen.
The system prompts you to confirm the circuit ID.
5 Press to confirm the circuit ID and exit the System Inventory screen.
Executing the default option from either the front panel or System Settings screen has no effect
on the ID values.
H
ENTER
E
C