1. On the remote control, press and hold
SETUP
until the last-selected device key blinks twice.
2. Enter
9 8 0
. The last-selected device key blinks twice, pauses, and blinks twice again to confirm that all
custom programming is cleared.
TROUBLESHOOTING
PROBLEM:
Device key does not blink when you press a key.
SOLUTION:
Replace the batteries with two (2) new AA batteries (see “Installing Batteries” on page 8).
PROBLEM:
Device key blinks when you press a key, but home entertainment device does not respond.
SOLUTION:
Make sure you are aiming the remote control at your home entertainment device and that you are
within 15 feet of the device you are trying to control.
PROBLEM:
The remote control does not control home entertainment devices or commands are not performing
properly.
SOLUTION:
Try all listed codes for the device brand being set up. Make sure all devices can be operated with an
infrared remote control.
PROBLEM:
TV/VCR Combo does not respond properly.
SOLUTION:
Use the VCR codes for your brand. Some combo units may require both a TV code and a VCR code for
full operation (see page 9).
PROBLEM:
No volume on a second TV.
SOLUTION:
Follow instructions under “Changing Volume Lock” on page 12.
PROBLEM: PLAY
and
STOP
keys do not work on a Motorola DCT-2000 cable converter.
SOLUTION:
Re-program the STB key for cable code 0476 (see “Programming Device Control” on page 8).
PROBLEM:
Tried Search Method and still could not find a working code.
SOLUTION:
Try the Search Method again after clearing out the device key as follows:
a. Press and hold
SETUP
until device key blinks twice.
b. Enter
9 9 2
.
c. Press and release the device key to be cleared twice.
PROBLEM:
Remote control does not turn on Sony or Sharp TV/VCR Combo.
SOLUTION:
For power on, these products require programming TV codes on the remote control. For Sony, use TV
code 0000 and VCR code 0032. For Sharp, use TV code 0093 and VCR code 0048.
FCC NOTICE
This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
This equipment has been verified to comply with the limits for a class B computing device, pursuant to FCC Rules. In
order to maintain compliance with FCC regulations, shielded cables must be used with this equipment. Operation with
non-approved equipment or unshielded cables is likely to result in interference to radio and TV reception. The user is
15
