b. Press and hold
SETUP
until the
STB
key blinks twice.
Using the Master Power Key
1. After programming, point the remote control at the devices. Press
STB
once.
2. Press
POWER
once to sequentially turn the programmed home entertainment devices on or off.
You will see the devices turn on or off according to the programmed sequence.
Clearing the Master Power Key
1. On the remote control, press and hold
SETUP
until the last-selected device key blinks twice.
2. Enter
9 9 5
. The last-selected device key blinks twice.
3. Press and release
POWER
.
4. Press and hold
SETUP
until the
STB
key blinks twice.
RE-ASSIGNING DEVICE KEYS
The Potenza ST Universal Remote Control can be set up to control a second device of an already-assigned type. For
example, to have the unit control a TV, a set-top box, and
two
audio devices (for example, two audio receivers), re-
assign the unused
AUX
key to operate the second audio device as follows:
NOTE: AUX
is preset at the factory to control an RCA VCR. Performing the steps below will over-write
those settings.
1. On the remote control, press
VCR
once; it will blink once. Then press and hold
SETUP
until the
VCR
key blinks twice.
2. Enter
9 9 2
. The
VCR
key will blink twice.
3. Press
AUD
once, then press
VCR
once. The
VCR
key will blink twice.
The
VCR
key is now ready to be programmed for your second audio device. See “Programming Device Control” on
page 8. To re-assign other device keys, repeat these and substitute the key sequence using the following chart:
NOTE:
Only one device can be assigned to an unused device key at a time.
To Re-Assign
Perform Key Sequence
AUX as 2
nd
AUD key
AUX -> SETUP -> 9 -> 9 -> 2 -> AUD -> AUX
AUX as 2
nd
TV key
AUX -> SETUP -> 9 -> 9 -> 2 -> TV -> AUX
AUX as 2
nd
DVD key
AUX -> SETUP -> 9 -> 9 -> 2 -> DVD -> AUX
AUX as 2
nd
DVD key
AUX -> SETUP -> 9 -> 9 -> 2 -> STB -> AUX
AUX back to
AUX key
AUX -> SETUP -> 9 -> 9 -> 2 -> AUX -> AUX
To re-assign another unused device key, substitute it for the
AUX
key above and then perform the sequence. For
example, to re-assign an unused
AUD
key as a second
DVD
key, perform
AUD -> SETUP -> 9 -> 9 -> 2 -> DVD -> AUD
When a re-assignment is done, the selected device key (e.g.,
AUD
) will blink twice to confirm your choice. At that time,
you will need to program device control (see “Programming Device Control” on page 8).
CLEARING CUSTOM PROGRAMMING
The Potenza ST Remote Control contains a
Custom Programming Reset
program. You can use it to remove all custom
programming, except your setup codes and reassigned device keys.
IMPORTANT:
Executing this program will erase all custom settings for Volume Lock, Learned Keys,
Tune-In Keys, and Channel Lock. However, your device programming remains.
14
