ADB EURODIM TWIN TECH, User Manual, Page: 29 / 96

EURODIM TWIN TECH
Page 27 sur 92
Reminder
The referencing of the modules in the cabinet starts at 1 in relation to the first location located at the top of
the cabinet, up to 32.
The left-hand column contains the referencing of the modules and circuits present in the cabinet.
The figure in the right-hand column is the channel attributed in the DMX signal.
Select patch A or B to start with
Use the wheel to rapidly move between all the rows of the patch. The row selected is highlighted.
To attribute a channel, position on a row and use:
−
The touch-screen and the numeric keyboard to enter a value,
−
Press key 1 directly to increment the value by 1 (between 1 and 512) in relation to the first value
available on a previous row,
−
Press key 0 directly to decrement the value by 1 (between 1 and 512) in relation to the first value
available on a previous row,
−
The Range key in order to enter values between two circuit references.
Important : Specific case for row 1/1: if key 0 or 1 is used, the value taken into consideration corresponds to
the content of output 128 if available, otherwise output 127, and so on.
If the value entered is 0 or greater than 512, the circuit is not controllable and the message
"Not used" is displayed.