Figure 5b - Internal Radar Gun swivels both
Horizontally & vertically for diverse aiming options
6. PROGRAMMING THE DISPLAY
Now that your dolly is in position, and the “SPEED LIMIT” sign is set; you are ready to
power up.
For the 510 Only
- flip the toggle switch at the underside of the display
enclosure to “ON”. The 500/525 have a keyed on/off switch. Your display should light up
and flash a number between 0 and 9. This is the ambient light indicating level that
adjusts the LED’s brightness to meet the existing conditions automatically. Next locate
a small push button next to the “On/Off” switch on the bottom of the enclosure. This
programming button, or use your remote, will set up the display features on the
FAST
500/510/525
.
Figure 6
Key Chain Remote Control
•
The left button directs the numbers up with the other directing down. When
the sign is in run mode, holding both buttons in for 1 second resets the sign
without having to cycle the power key.
•
To replace its battery, remove the small Phillips head screw located on the
lower back and replace with a type 27A, 12volt alkaline cell.
The speed codes and their meanings
Read over the following programming codes listed in the Speed Code Table
below to become familiar with the two-letter groups (modes) you want to set in
the sign using the push button. Concentrate on the “Normal Mode” (NM) and
“Violator Alerts”
(VA) modes only, for now.
Notice that they are grouped so that for
example, when
“VA” is selected, you can set the “Minimum Speed”, Flash (speed), Blank (speed),
etc. As the last numbers are entered, the display is ready and goes blank.
Adaptive Micro Systems LLC | 7840 North 86th Street | Milwaukee, WI 53224
Phone (800) 558-7022 | AdaptiveDisplays.com
