attached and stable for a continuous 30 seconds, the “smart charger” will not begin charging
and the corresponding lights for the battery bank in question will FLASH. If the battery is
connected in reverse, it is considered an unstable battery, the corresponding lights for the
battery bank in question will FLASH and battery will not be charged. If the charging leads
are disconnected in the middle of the charge cycle, it will turn the charge current off to help
eliminate any possibility of spark. If the charging leads are loose and making intermittent
contact, the “smart charger” will not turn current on. This also helps eliminate spark.
***
Please note:
Charger model may vary. The indicator light instructions are general and
may not apply to your unit.
11. MAINTENANCE, CLEANING, & CARE
Sign & Enclosure:
Your entire FAST 500 sign has been powder coated for a long-lasting
great look. While powder coat finishes are tougher and much more
flexible than conventional solvent based paints, they are about the same
hardness as automotive paint, so they will scratch. To clean a powder
coated surface, use the same care and methods you would use to clean
your car. Gently wash with a clean, soft cloth and a mild detergent
followed by a clear water rinse. Even though most powder coatings are
highly resistant, certain solvents can harm them. Avoid contact with nail
polish remover, paint or lacquer thinner, motor oils, transmission and
brake fluids or parts cleaning fluids. If any of these should contact the
powder coated surface, immediately wipe the area with a soft, clean
cloth, and wash as described above.
Lexan Screen:
Your display screen carries a 5-year limited warranty against
breakage. However, to prevent scratching, please take care to
use only the proper cleaning products and techniques
outlined here;
1.
Rinse with lukewarm water; Wash gently with mild soap or
detergent and lukewarm water, using a soft cloth or sponge.
DO NOT SCRUB or use brushes or squeegees.
2.
Rinse again. Dry with soft cloth or moist cellulose sponge to
prevent water spotting.
3.
To remove wet paint, glazing compound or grease, rub
lightly with a good grade of VM&P naptha or isopropyl
alcohol, then wash and rinse. DO NOT USE GASOLINE.
4.
Compatible Cleaning Agents include Fantastik, Formula 409,
Hexcel, F.O. 554, Joy, Lysol, Mr. Clean, Neleco-Placer, PineSol,
Top Job, & Windex.
Wheel Hubs: Check the grease level periodically as it may deplete depending on the
amount of use (mileage). A minimum of every 6 months
is recommended.
Battery: Your FAST 500 Sign is equipped with the highest quality, AGM, deep
cycle, sealed, spill-proof, leak proof, DOT approved battery that
requires
Adaptive Micro Systems LLC | 7840 North 86th Street | Milwaukee, WI 53224
Phone (800) 558-7022 | AdaptiveDisplays.com
