SPEED CODE TABLE
Two-letter Mode Meaning
Description
NM
=>
“Normal Mode”
Sign shows all speeds
normally with no speed
filtering
VA
=>
“Violator Alert”
MS => “Minimum. Speed”
SL
=>
“Slow Down”
RB
=>
“Red & Blue”
FL => “Flash”
BL => “Blank”
“
Violator Alert”
MENU
Min. speed for sign to display
Speed at which red “SLOW
DOWN” shows (Optional Feature)
Flashing “Red & Blue” speed
(Optional Feature)
Speed at which to flash readout
Speed at which to blank screen
**
ND
=>
“No Display”
Unit collects radar data with no display
**
OPTIONAL ONLY
for units with the
optional data collection software feature.
Feature must be enabled - See
Advanced Features Mode Section.
SETTING THE SIGN IN “NORMAL MODE”
The simplest mode to put the sign into is the “NM” (Normal
Mode). Instructions:
1. Turn the power on with the key. After the brightness number changes,
start pushing the button and stop on the two letter code “NM”.
2. As the display goes dark, it is now running in “Normal Mode”. In other
words, the sign will display the speed of oncoming vehicles from 5 mph
(down to 1 mph is also available, see Advance Features Section) to 99
MPH without showing any alerts. So for this code only, no further
programming would be needed.
PROGRAMMING THE SIGN IN “VIOLATOR ALERT” MODE
This section covers setting the standard “Violator Alert” functions including the
optional “Slow”, “Red & Blue” flashing signals.
Note:
The pushbutton instructions
described in the following paragraphs also apply to the use of the key chain remote
control buttons.
Turn power on. After the brightness number changes, push the button and stop on
“VA”. The display is now in “Violator Alert” setup mode. The Violator Alerts 1 to 5 will
then begin to appear in the order of the photos as shown below.
Note:
If the
Adaptive Micro Systems LLC | 7840 North 86th Street | Milwaukee, WI 53224
Phone (800) 558-7022 | AdaptiveDisplays.com
