XL-SEAT
2005-2011 DODGE DAKOTA QUAD CAB PASSENGER
p. 6
ELECTRICAL INSTALLATION FOR XL-SEAT
1.
Thread the lead power cable (red +) under the doorstep moulding and thru the
firewall. WARNING: Pass thru a grommet in the firewall to prevent the cable from
chaffing.
2.
Install the circuit breaker near the battery and then
connect the battery to the circuit breaker.
3.
Attach the ground wire (black -
) to the vehicle’s frame,
under the doorstep moulding using a self tapping screw.
(NOTE: It is preferable to locate it in a spot where the sheet
metal is doubled-up to insure a better ground.)
4.
Connect the power cable (red+) and the ground cable
(black -) to the electronic module (black box). Place the
electronic module under the seat and secure it in place
u
sing “Velcro”. Secure all the wires in a loom. Reconnect
the battery.
5.
Thread the flat hand held control wire (black telephone
wire) under the doorstep molding and up under the dash. Secure the
wire in place under the dash with a tie wrap and secure the hand
held control on the dash using “Velcro”.
WARNING: Place the hand held control in a safe place so that the
door does not risk cutting off the wire.
