122
E1
Robot outside
the working
area
Check if the robot is within the working area. If yes:
1. Check that the charging station is correctly connect-
ed to the power supply and the plug socket.
2. Check that the boundary wires are correctly plugged
into the charging station’s plug socket (red/black).
E11
No boundary
wire signal
Check the LED light on the charging station while
the robot is switched on inside the working area.If
this lights up red, it means that the boundary wire is
disconnected.
1. Then check that the boundary wire is correctly at-
tached to the charging station.
2. Check for breaks in the boundary wire.
E2
Wheel motor
blocked
(locked/dam-
aged)
1. Turn the robot off completely (hold down the off
button) and carry it to a flat area free of obstacles.
2. Turn on the robot, enter the password, press START
and then OK
3. If the error message still appears, turn the robot off.
Turn the robot upside down and check if there is any-
thing preventing the wheels from rotating.
4. Remove any obstacle blocking the wheels, turn the
robot back on, press START and then OK.
E3
Cutting blade
blocked
1. Turn off the robot completely (hold down the off
button)
2. Turn the robot upside down and check if there is
anything preventing the blade disc from rotating
3. Remove any obstacle blocking the blade disc.
4. Move the robot to an area with short grass or adjust
the cutting height to max. (60 mm). Turn it on, press
START and then OK.
E4
Obstacle sen-
sor does not
work.
1. The top cover may not be installed correctly. Press it
firmly down over the machine
2. Turn off the robot and carry it to a flat area free of
obstacles.
3. Remove the top cover (see section 20) and check for
two round magnets next to each other on the inside, at
the front near the inner edge. If the magnets are miss-
ing, you will need to replace the top cover.
4. Turn on the robot, press START and then OK.
Display
Message
Solution
ERROR CODES
