Adam Equipment PTS plus Series, User Manual

Page: 9 / 20

3.0 INSTALLATION
Please follow the installation instructions to ensure correct operation of your PTS plus. In
transportation the handle is removed from the truck, this needs to be installed following the
instructions below:
NOTE: Do not lower the handle down fully until completing the instructions below.
1) Insert the roller pin into the hole of roller rack, securing the handle to the frame
2) Fit the split pin through the holes provided.
3) Pass the chain through the center hole of the roller pin. Secure the end of the chain
to the slot on the end of the unloading plate.
4) Remove the transit rod before use. Press the handle down only far enough to
release any pressure on the transit rod, then pull the transit rod free.