Page 33 of 48
When FORM 1 or FORM 2 is selected the user can set the information to be
printed on each line of the form. Pressing the
[Up]
or
[Down]
keys will cycle
through the options available. The options are:
INST ID
Instrument ID number
SER No
Serial Number
TIME Time
DATE Date
NET
Net Weight (Gross weight – Tare Weight)
GROSS Gross
Weight
TARE Tare
Weight
UNIT
Unit weight in parts counting mode
COUNT
Number of items in parts counting mode
REF
100% weight in percent weighing mode
PERCENT Percentage
of
reference
weight in percent weighing
LO LIMIT
Low Limit when check weighing
HI LIM
High Limit when check weighing
Cr Lf
Inserts a blank line
END
Signifies the end of the report
When END is entered the display returns to the RS-232 Sub-menu
Enter the data to be printed on the first line by pressing the
[Up]
or
[Down]
key to cycle through the options. If the current information is OK then press
the
[Setup]/Enter
key to move to the next line.
e.g. “LINE No1” “DATE” - prints date
Select a code for one of the preset data formats as detailed above.
The next line shows: “LINE NO 2” “TIME” - prints time
Only one item can be entered per line.
Continue until the formatting of the form is complete. There are 15 lines of
possible data. After the 15
th
line has been set or “END” has been selected,
the balance will return to the RS-232 Sub-menu.
Press
[Mode]
to advance to setting of the next menu or press
[Esc]
to return
to normal weighing.
13.4 SETUP PARAMETERS
The user parameters that control the balance are shown under the SETUP.
When “SETUP” is displayed, press the
[Setup]/Enter
key. The options for
each parameter can be scrolled through by using the
[Up]
or
[Down]
key.
© Adam Equipment Company 2007
