Adam Equipment Nimbus NBL Serie, Operating Manual

Page: 26 / 264

EN
© Adam Equipment Company 2015
24
3016612481Rev2.00-Jul15
10.4.3.3
Dynamic (Animal) Weighing Setup Parameters
When the “
Dynamic
” symbol is displayed, and you have selected “ SEtvP
SEtvP SEtvP
SEtvP ” to set up the
balance for dynamic weighing (see section 10.4.3.3 on Dynamic Weighing Setup
Parameters):
Press [Setup] to select “
SEtvP
SEtvP SEtvP
SEtvP ” to change the dynamic weighing mode settings.
The display will show “
MODE MODE MODE MODE ”. Press [Setup] again and use the [Up] or [Down] keys to
select “ AvtO
AvtO AvtO
AvtO ” or “ mmAnvAL
mAnvAL mAnvAL
mAnvAL ”.
If “
AvtO
AvtO AvtO
AvtO ” or “ mmAnvAL
mAnvAL mAnvAL
mAnvAL ” is selected, the following 4 parameters are available:
•
Threshold “ THRESH THRESH THRESH THRESH ”
•
Mode “ mode mode mode mode ”
•
Delay “ DE DE DE DELAY LAY LAY LAY ”
•
Test time “ TEST T TEST T TEST T TEST T ”
10.4.3.3.1 Threshold “ THRESH THRESH THRESH THRESH ” (For Auto mode only)
Press [Setup] when “ THRESH
THRESH THRESH
THRESH ” is shown and the display will next show the minimum
weight of the item required by the balance to start the process for dynamic weighing. The
value shown will be the current value in the last selected unit.
The minimum threshold value can be changed from 1.0 to 100 grams using the keypad
numeric entry method. If a value outside this range is selected then it will not be accepted
and “
ER LOW ER LOW ER LOW ER LOW ” or “ ER HIGH ER HIGH ER HIGH ER HIGH ” will be displayed followed by return to the weight entry screen
again.
To confirm the desired value, press [Setup] or to escape without changing the value,
press [Mode].
10.4.3.3.2 Mode “ mode mode mode mode ”
Auto “ AvtO
AvtO AvtO
AvtO ” or Manual “ mmAnvAL
mAnvAL mAnvAL
mAnvAL ” modes are available. Whichever mode is visible when
[Setup] is pressed becomes the active mode. Auto starts dynamic weighing test as soon
as weight exceeding a set threshold is loaded on the pan. Manual requires the user to
load the pan and then press a button before weighing commences.
10.4.3.3.3 Delay “
DELAY
DELAY DELAY
DELAY
”
Press [Setup] when “
DELAY
DELAY DELAY
DELAY
” is shown and the display will next show the number of
seconds pause before the sampling starts. The Delay value can be changed to between 0-
99 seconds using the keypad numeric entry method. If a value outside this range is
selected then it will not be accepted and “
ER LOW ER LOW ER LOW ER LOW ” or “ ER HIGH ER HIGH ER HIGH ER HIGH ” will be displayed followed
by return to the time entry screen again.
To confirm the desired value, press [Setup] or to escape without changing the value,
press [Mode].
10.4.3.3.4 Test time “ TEST T TEST T TEST T TEST T ”
Press [Setup] when “ TESt t TESt t TESt t TESt t ” is shown and the display will next show the number of
seconds over which the balance will average to compute the final weight. The Test time