Adam Equipment Eclipse EBL Series, Operating Manual, Page: 29 / 116

EN
© Adam Equipment Company 2015
27
3016612482 Rev1-Aug15
Place the item on the pan. The animal weighing test will begin automatically.
After the pre-configured delay and test time have elapsed (see section 10.4.4.3 on
Dynamic Weighing Setup Parameters), the “
HOLD
” symbol and the result will be displayed.
Remove the item from the pan. Press [Mode] to go back to “
rUN rUN rUN rUN ” to weigh another item, or
[ 0/T  ] to return to normal weighing.
10.4.4.3
Animal (Dynamic) Weighing Setup Parameters
When the “
Animal
” symbol is displayed, and you have selected “ SEtvP SEtvP SEtvP SEtvP ” to set up the balance
for dynamic weighing (see section 10.4.4.3 on Dynamic Weighing Setup Parameters):
Press [Select] to select “
SEtvP
SEtvP SEtvP
SEtvP ” to change the dynamic weighing mode settings.
The display will show “
MODE
MODE MODE
MODE ”. Press [Select] again and use the [Up] or [Down] keys to
select “ AvtO AvtO AvtO AvtO ” or “ mmAnvAL mAnvAL mAnvAL mAnvAL ”.
If “
AvtO
AvtO AvtO
AvtO
” or “
mmAnvAL
mAnvAL mAnvAL
mAnvAL
” is selected, the following 4 parameters are available:
•
Threshold “ THRESH THRESH THRESH THRESH ”
•
Mode “ mode
mode mode
mode ”
•
Delay “ DELAY DELAY DELAY DELAY ”
•
Test time “ TEST T TEST T TEST T TEST T ”
10.4.4.3.1 Threshold “ THRESH THRESH THRESH THRESH ” (For Auto mode only)
Press [Select] when “
THRESH
THRESH THRESH
THRESH
” is shown and the display will next show the minimum
weight of the item required by the balance to start the process for dynamic weighing. The
value shown will be the current value in the last selected unit.
The minimum threshold value can be changed from 1.0 to 100 grams using the keypad
numeric entry method. If a value outside this range is selected then it will not be accepted
and “
ER LOW
ER LOW ER LOW
ER LOW ” or “ ER HIGH
ER HIGH ER HIGH
ER HIGH ” will be displayed followed by return to the weight entry screen
again.
To confirm the desired value, press [Select] or to escape without changing the value,
press [Mode].
10.4.4.3.2 Mode “ mode mode mode mode ”
Auto “
AvtO
AvtO AvtO
AvtO
” or Manual “
mmAnvAL
mAnvAL mAnvAL
mAnvAL
” modes are available. Whichever mode is visible when
[Select] is pressed becomes the active mode. Auto starts dynamic weighing test as soon
as weight exceeding a set threshold is loaded on the pan. Manual requires the user to
load the pan and then press a button before weighing commences.
10.4.4.3.3 Delay
“ DELAY DELAY DELAY DELAY ”
Press [Select] when “ DELAY DELAY DELAY DELAY ” is shown and the display will next show the number of
seconds pause before the sampling starts. The Delay value can be changed to between 0-
99 seconds using the keypad numeric entry method. If a value outside this range is