Adam Equipment AEA Series, Operator'S Manual

Page: 8 / 24

© Adam Equipment Company 2000 8
Use the same method to set:
M6 02 Liquid
M6 03 Temperature, if water or alcohol is selected
M6 04 Density if another Liquid is selected.
Start the procedure:
Set the cursor next to
M6 04 Run
Enter the Density mode
OR
At any time press Print/enter to enter the Density mode
Make sure the Density Kit is assembled correctly and there are no air bubbles on any of the
parts in the liquid. Tare the balance if necessary to zero the display.
The display will guide you through the steps of weighing the sample in air and then weighing
it in the liquid.
1. Put the sample on the small test pan above the liquid.
2. After the result is stable (the unit of mass is on) press .