Ada ROTARY 400 HV, Manual

Page: 18 / 36

OPERATION FROM THE REMOTE CONTROL
1. Press bu�on (№3 pic 3) on the remote to switch off a SHOCK WARNING
mode. Indicator (№3 pic 2) on the tool’s keypad is switched off.
2. To sw�ch SHOCK WARNING mode again, press bu�on (№3 pic.3). Indicator
(№3 pic 2) on the tool’s keypad is switched on.
④
INCLINED PLANE (MANUAL MODE)
Rotary laser level can make an inclined plane along one or two X and Y
axis simultaneously. Slope value is ±5º. The �lt angle is created regarding
the axes indicated on the protec�ve cover of the rota�ng laser head (pic.4).
IMPORTANT: TILT CONTROL ALONG THE AXES IS POSSIBLE ONLY
FROM THE REMOTE CONTROL.
OPERATION FROM THE TOOL KEYPAD
1. Press bu�on (№5 pic.2) to switch the manual mode on. Indicator (№6
pic.2) of the manual mode is on.
2. Control the �lt along the axes from the remote control using the bu�ons
(№ 4, 6,7,8 pic.3).
3. Press bu�on (№5 pic.2) to exit the manual mode. Indicator (№6 pic.2) will
blink off, automa�c self-leveling will switch on.
OPERATION FROM THE REMOTE KEYPAD
1. Press bu�on (№2 pic.3) to switch o the manual mode. Indicator (№6
pic.2) is switched on on the keypad of the tool.
2. Press and hold bu�on (№5 or №7 pic.3) to set the inclina�on along Y axis.
Pless and hold bu�on (№6 or №8 pic.3) to set the inclina�on along X axis.
3. To exit manual mode press bu�on (№2 pic.3). Indicator (№8 pic.2) will
light off. Automa�c self-leveling mode will be switched off.
SCAN FUNCTION
The scanning func�on is used to improve the visibility of the laser beam and
eliminate interference when several rotary lasers are opera�ng
simultaneously on the same area. The area where the laser beam is visible is
limited.
The smaller the scanned object, the be�er it is seen. There are 5 variants
of scanning: 0°- 10°- 45°-90°- 180°.
IMPORTANT: SCAN FUNCTION CAN BE ACTIVATED FROM THE REMOTE
CONTROL ONLY.
18