- 31 -
Step F - Connection of Home Theater Systems
The Genesis system provides several different options when it comes to home theater systems.
These options are discussed on pages 22-25.
Step G - Speaker Wires
Connect the speaker wires to the Genesis or other power amplifiers. Use the screw terminal
speaker connectors on the Genesis and the banana connectors common found on most ADA
power amplifiers. The banana connectors have a tab on one side marked "GND" for ground.
This tab will permit you maintain polarity even if you cannot see the wires as you plug them into
ADA power amplifiers. For the four pin screw terminal connector on the Genesis, follow the
format as printed on the rear of the Genesis. For a diagram of the Genesis's rear panel
connection, go to pages 18-19.
Step H - Control Cable Connections to Keypads & Genesis
At this time, you should have already toned out control cable lines to verify that no shorts exist
on the cables and that continuity across all wires is OK. At this time you can proceed to connect
(if not done previously) the removable screw terminal connectors to the control cable at both
the mainframe and remote room. Make certain that you have properly labeled all wires as they
are room specific. Once you have the cables connected to the screw terminal connectors, plug
the connector into the appropriate keypad or Genesis control port. For more information on
proper keypad and Genesis connections, go to pages 18-19.
Step I - Main AC Connections
Once your system is properly connected, you can proceed to plug the main AC components
into an AC outlet. These devices include the Genesis, ACC-3, and any other AC components
that may as yet not have been plugged in.
