- 12 -
If you did not send an IR command within six seconds, the IR learner will time-
out indicating the 2nd, 4th & 5th LEDs. If this happens, press the IR learner
button on the rear of the Genesis twice, once to exit the programming mode
and the second time to re-enter the programming mode.
6
Once you have programmed the first function into the Genesis, continue
programming the remaining functions for this source by repeating steps 4
and 5.
7
Once you have programmed the functions for the first source, proceed to
program the second source by simply pressing the next source button on the
front of the Genesis.
Testing Programmed IR Codes
After you have programmed all three sources into the Genesis, you can verify the
functions providing the source components are available. To verify the program-
ming:
1
Connect an IR flasher to the Genesis's IR output jack and aim it (stick it) at
the front of the first component you wish to test.
2
Select the source button that this source's IR codes were programmed into
on the front of the Genesis.
3
Press the function button (Power On, 1st, 2nd) on the back of the Genesis
one at a time and verify the components response to each code. With each
press of a transport function that was programmed correctly, the Genesis top
LED will flash.
If a transport function is selected that has nothing programmed on it, the
second from the top LED will flash.
4
After you have tested the first source, connect the second source to the IR
flasher and press the corresponding source button on the front of the
Genesis.
