Acute Communication Services Pvt. Ltd.
10
Installation Steps of Device
10.1
Power Connection – Commercial Vehicles
➢
Remove the Ignition Key
➢
Run Red (+ve) and Black (-ve) wires from the battery till the location of the device placement.
Ensure that the wiring is done firmly and neatly without any hanging or sagging of wires. Use
self-adhesive cable Tie mounts and cable ties to do the wiring.
➢
Connect Red wire of ACUTE140 device power cable (Long Cable) to the +ve (Red) cable drawn
from the vehicle battery and ensure that the connection is firm.
➢
Connect the Black wire of the Bharat 101 device power cable (Long Cable) to the (-ve) Black
wire drawn from the vehicle battery and ensure that connection is firm.
➢
Check if the dash board is made of Metal or Plastic/ Fiber
➢
If the dash board is made of metal, install the device outside the dash board only
➢
If the dash board is made of Fiber or Plastic, Device can be installed inside the dash board
10.2
Power Connection – Personal Vehicles
➢
Remove the Ignition Key
➢
Identify the power line Positive (+) cable coming from the battery to the ignition switch by
measuring the voltage between each of the wire coming in to the ignition switch assembly.
➢
See if the metal conductor in the Connect or wire connection point at the ignition switch
is accessible; else peel off the skin from each of the wire.
➢
Firmly hold the (+) Red probe of the multi-meter to the wire conductor and (-) Black probe
of the multi-meter to the GND point (-) terminal of the vehicle battery or any screw / bolt
directly connected to metal body of the vehicle).
➢
Voltage at the (+) wire of the (Incoming supply line) ignition should be matching to the
battery voltage of the vehicle
➢
Check the voltage at the Ignition input point at
o
Voltage OFF condition
o
Vehicle Ignition ON condition
o
Vehicle Engine start condition
o
Maximum acceleration at Neutral/Stationary
➢
In any condition, the voltage should not exceed 36V. Please do not install the device in
the vehicle if the voltage is beyond 36V
