Acura 2009 TL Navigation System, Owner'S Manual

Page: 97 / 650

CONTINUED
You can customize some vehicle
control settings. To change the
settings, the ignition switch must be
in the ON (II) position, and the
vehicle must be stopped with the
transmission in Park.
If you turn the ignition switch to the
ACCESSORY (I) or the LOCK (0)
position, or move the shift lever out
of Park, the display will change to
the normal screen.
Models equipped with the keyless
access system have an engine start/
stop button instead of an ignition
switch. VEHICLE OFF (LOCK)
Mode is the equivalent of LOCK (0);
and ACCESSORY Mode is the
equivalent of ACCESSORY (I). See
page
for ignition switch and
power mode comparison.
If you try to enter the customizing
mode while the vehicle is moving,
you will see a ‘‘MUST STOP AND
SHIFT TO PARK TO CHANGE
SETTINGS’’ message and you
cannot change the settings.
You can customize some vehicle
control settings for ‘‘DRIVER 1’’ and
‘‘DRIVER 2’’ separately.
To have the driver’s ID detected,
make sure the driver’s door is
unlocked with a corresponding
remote transmitter/keyless access
remote.
Make sure your remote transmitter
is linked to the system. You can
confirm the driver’s ID on the
welcome screen when you turn the
ignition switch to the ON (II)
position.
See page to link your remote
transmitter to your vehicle.
If the remote transmitter is not
linked, ‘‘CUSTOMIZING NOT
AVAILABLE UNTIL LINKED TO
REMOTE’’ will be displayed, and you
cannot customize the settings.
If you use the key to unlock the
driver’s door, the system cannot
recognize either ‘‘DRIVER 1’’ or
‘‘DRIVER 2.’’
180
154
On models without keyless access
system
Multi-Information Display
Keyless Memory Settings
Inst
ru
m
e
nt
s
a
nd
Cont
ro
ls
91
TM
０８／０７／２９ １７：３６：１３ ３１ＴＫ４６００ ００９６