4 of 7
BII 28356 (0411)
© 2004 American Honda Motor Co., Inc. - All Rights Reserved.
8.
Wrap one wire tie with clip around the bus cable,
and push the wire tie with clip into the hole in the
vehicle frame.
9.
Secure the bus cable to the vehicle harness with
one wire tie.
10. Insert the studs from the right and left upper
player brackets into the holes in the vehicle frame,
and install one 6 mm flange nut to each stud.
Push the player brackets outward, and tighten the
flange nuts.
3305050S
LEFT UPPER
PLAYER
BRACKET
6 mm FLANGE NUT
STUDS (2)
RIGHT
UPPER
PLAYER
BRACKET
STUDS (2)
6 mm FLANGE NUT
2N21101S
BUS
CABLE
HOLDER
OPENING
VEHICLE
14-PIN
CONNECTOR
VEHICLE
14-PIN
CONNECTOR
MASKING TAPE
14-PIN
CONNECTOR
VEHICLE
14-PIN
CONNECTOR
BUS CABLE
14-PIN CONNECTOR
BUS
CABLE
2N02021S
WIRE TIE WITH CLIP
WIRE TIE
VEHICLE
HARNESS
VEHICLE
FRAME
BUS
CABLE
7.
Plug in the bus cable.
•
Apply masking tape in the areas shown.
•
At the holder opening, unplug the vehicle
14-pin connector, and plug the bus cable
14-pin connector into the vehicle 14-pin
connector.
NOTE: Failure to attach masking tape to
protect the bottom edge of the AUDIO-HVAC
display module can result in damage. The
AUDIO-HVAC display module is available only
as a complete assembly.
