HOLOPHANE
®
Wallpack
®
Full Cutoff
Installation and
LED Luminaire (HLWPC2)
Maintenance
Manual
IM‐438‐B
2.7 Optional 0-10V DC Dimming Controls Information
2.7.1
Certain control options available with the
Wallpack® Full Cutoff LED luminaire have 0-10V DC
dimming capabilities. General information for each is as
follows:
2.7.2
For the field adjustable output (AO) module, the
default setting is position 8 on the dial, which
corresponds to 100% output. Output and can be
adjusted by rotating the center dial. See tables 2-6 for
additional dial settings and their corresponding outputs
based on performance package. AO Tables are included
on the last page of this installation manual.
2.7.3
For the occupancy sensor options (MASL &
MASH), see luminaire spec sheet for specific mounting
height information but in general the MASL option
mounting height should not exceed 15’ and the MASH
option mounting height should be between 15-30’ –
Specific programming instructions for these devices is
included in a separate document, included with the
luminaire.
2.7.4
The part-night dimming (PND) option requires no
special steps – the device comes preprogrammed.
2.7.5
For the NEMA twist-lock photocontrols (P3 and P7
options), installed control nodes are sold separately and
are not supported by Holophane product support.
3 Maintenance
3.1 Electrical Component Replacement
3.1.1
Disconnect power to the luminaire location before
maintenance.
3.1.2
Open luminaire by loosening 6 heatsink screws
and removing the heatsink from the electrical housing.
Depending on the device being serviced/replaced it may
be easiest to completely remove the heatsink from the
electrical housing. Drivers and fuses are mounted to the
heatsink, surge devices are mounted to the electrical
housing.
3.1.3
Tag leads before disconnecting if they are not
already labeled.
3.1.4
Replace components using Holophane approved
replacement parts.
3.1.5
Re-connect electrical leads. See sections 2.3, 2.4,
or 2.5 depending on luminaire configuration.
3.1.6
Reattach heatsink to electrical housing. See
section 2.6.
3.2 Heatsink - Optical Housing
3.2.1 There are no user serviceable parts in the optical
housing portion of the heatsink.
4 Limited Warranty and Limitation of Liability
4.1
5-year limited warranty. Complete warranty terms
located at:
www.acuitybrands.com/CustomerResources/Terms_and
_Conditions
